Description
Technical Specifications
| Parameter | Specification |
|---|---|
| Manufacturer | B&R Industrial Automation |
| Model | 5AC600.FLAP-K11 |
| Product Family | Automation PC 600 |
| Product Type | Interface Access Flap / Slot Cover |
| Primary Function | Protects chassis access opening |
| Installation | Automation PC 600 chassis |
| Mechanical Function | Access-port/slot protection |
| Electrical Function | None directly |
| Communication Function | None directly |
| CPU Function | None |
| I/O Function | None |
| Material | Not independently verified |
| Gasket | Verify against physical revision |
| Latch/Hinge | Verify against actual part |
| Compatibility | Exact chassis/interface configuration should be checked |
Product Introduction
The B&R 5AC600.FLAP-K11 is a mechanical accessory for the B&R Automation PC 600 platform. It should not be classified as a PLC CPU, communication card, or I/O module. The available product reference identifies it as an interface cover designed to close an access opening on the industrial PC chassis.
The primary purpose of the B&R 5AC600.FLAP-K11 is physical protection. Keeping unused or service-access openings properly covered can help prevent contamination from entering the equipment enclosure and can preserve the mechanical integrity of the original chassis assembly.
This distinction is important because several secondary websites incorrectly describe 5AC600.FLAP-K11 as a complete industrial computer or generic slot-interface module, then assign unrelated processor, memory, Ethernet, USB, and operating-system specifications. Those specifications clearly describe an industrial PC rather than a small chassis accessory and should not be used as specifications for this part number.
5AC600.GPI0-K05
Main Features & Field Considerations
Automation PC 600 compatibility
The part is associated with the B&R Automation PC 600 platform and should be matched to the physical chassis before ordering.
Mechanical protection
Unlike an electronic expansion board, the FLAP-K11 has no independent processing or communication function. Its value is in maintaining the physical enclosure around the associated access/interface area.
Chassis-specific fit
Do not assume that every B&R Automation PC uses the same flap. Hinge geometry, mounting points, panel contours, and access-opening dimensions should be checked against the installed chassis.
Legacy replacement
For an older Automation PC 600 installation, a broken or missing cover can be a legitimate maintenance issue, particularly where the equipment is exposed to dust, oil mist, moisture, or conductive contamination.
Replacement Checks
Before purchasing a B&R 5AC600.FLAP-K11, verify:
- Exact part number:
- Automation PC model
- Chassis revision
- Access-opening location
- Hinge/mounting arrangement
- Latch geometry
- Gasket/sealing arrangement, if fitted
- Physical dimensions
- Condition of the mating chassis bezel
If the existing flap is damaged, inspect the chassis mounting points as well. A broken hinge or retaining tab on the main chassis can make a new cover unsuitable without additional repair.
Procurement Note
The safest description for B&R 5AC600. is:
B&R 5AC600. — Automation PC 600 Interface Access Flap / Chassis Cover
I would not publish IP65, NEMA 12, UL 94 V-0, -40 to +85°C, specific polymer composition, or guaranteed gasket specifications as confirmed technical data. Those details appear in a secondary listing but are not corroborated by a B&R primary document in the sources reviewed.
For procurement, match the exact 5AC600. marking and physical chassis configuration rather than relying on generic “Automation PC 600 cover” descriptions.
